A single component non-toxic, soft dry film lubricant consisting of a wax emulsion and wetting agents for use on metal and rubber surfaces.

Surface Preparation Apply to a clean and degreased surface. On metal, lightly grit blasting using 150 to 280 mesh aluminum oxide will increase adhesion. Application Can be applied by brush or dip. Allow to Air dry for 30 minutes before putting into use. Clean Up As soon as possible after coating and before the coating has dried on equipment, clean up with warm water. Precautions: Although water based material, spray droplets should not be inhaled. Use adequate ventilation. In confined areas, use adequate forced ventilation during application and drying. When spraying, a suitable protective vapor/particulate respirator should be worn. Also refer to the Sunlube Material Safety Data Sheet.