Flexrez 150 is intended for use as a binder for clear or pigmented coatings that require extremely high flexibility and excellent adhesion. Clean Up As soon as possible after processing and before coating has dried on equipment, clean up with warm water. If coating has been allowed to dry, it may be necessary to clean with a solvent such as lacquer thinner. Precautions Although water base material, spray droplets should not be inhaled. Use adequate ventilation. In confined areas, use adequate forced ventilation during application and drying. When spraying, a suitable protective vapor/particulate respirator such as #8709 manufactured by 3M Co., should be worn. In areas of minimum air movement, a fresh air mask such as #W-292 manufactured by #M Co. should also be used. Also refer to the FlexRez 150 Material Safety Data Sheet.

AC020是Alseal 519的水白色添加剂，可将固化温度降至*300°F（149°C）。

被感动最多的地区应使用脱脂溶剂，如酒精或甲基乙基彻底脱脂 酮。它是使用脱脂溶剂不留下残留物是很重要的。
Alseal 189P is a high temperature water-based two component phenolic / epoxy coating composition containing laminar orienting pigments. This coating provides a very hard, abrasion resistant, corrosion resistant, and chemical resistant barrier film at constant temperatures up to 400°F with intermittent peak temperatures of 600°F complemented by a near-zero VOC. Color Yellow or Light Gray Packaging One gallon containers are standard. Surface Preparation New metal surfaces should be cleaned of oil, grease and dirt. The surface should then be prepared by blasting, chemical treatment, or both depending on specific specifications and a proper Alseal basecoat applied